We should pay attention to daily maintenance while using electric motorcycles.We need to check the configuration in order.

(1) Whether the tire pressure is sufficient: If the tire pressure of the electric motorcycle is insufficient, it will increase the friction between the tire and the road surface, so it should be supplemented in time when the air pressure is insufficient.

(2) Whether the front and rear brakes are sensitive, and whether the whole motorcycle has abnormal noise: remember to adjust or release lubricating oil when the handlebar rotates inflexibly, and there are sticking points, stiff points or tight points. When adjusting, loosen the front fork lock nut first, rotate the upper gear of the front fork, and lock the front fork lock nut when the flexibility of handlebar rotation meets the requirements.

(3) Whether the screws are loose: if the screws are loose in the parts of electric motorcycle, they should be adjusted and tightened in time. If an abnormality is found during riding, which cannot be repaired by yourself, you should find a repair shop for repair in time.

(4) Whether the battery is fully charged: Before going out, look at the electric power of the electric motoecycle, and determine whether the power is sufficient according to the number of kilometers you travel. If the power is insufficient, give it in time to avoid the battery working under negative voltage.

(5) Motor:Check the working condition of the motor before going out. Start the motor and adjust its speed to observe and listen to the operation of the motor, and repair it if there is any situation.

(6) Charger: When charging a battery, you must use a matching charger, and you cannot mix battery chargers of various models; During charging, the battery and charger should be placed in a cool and dry place, away from inflammable and explosive articles, avoiding high temperature, humidity and water shower, and it is forbidden to cover them with articles, and it is forbidden for infants and children to contact them. After charging, disconnect the power grid first, and then separate the battery from the charger.

(7) Precautions in rainy and snowy weather: When water is involved, the water level should not exceed the lower edge of the bearing seat of the electric hub to prevent the motor from being damaged by water ingress.

(8) Electric bicycles should not be exposed to the sun for a long time. Long-term sunlight will cause paint to fall off the surface of electric motoecycles, and all kinds of plastic devices will age, which will shorten the service time of electric motoercycles.